We cannot Ship TWP 100 To Canada. We can ship the TWP 200 Series to Canada.
#1 Rated Wood Sealer/Stain!
TWP Total Wood Deck Stains and Protectant protects and preserves all exterior wood and decks. TWP Total Wood Preservative is a unique combination of chemicals in a professional-strength formula that protects and preserves exterior wood in several ways.
TWP Deck Stain prevents water absorption that causes warping, cracking, and splitting. Prevents freeze damage in colder climates.
TWP Deck Sealer Stops U.V. Damage – Special U.V. absorbers prevent unsightly wood graying, darkening, and fading. Wood stays beautiful longer.
TWP Wood Stain Prevents Wood Rot – Wood preservatives prevent structural damage and wood decay for above-ground surfaces. Especially important on untreated fencing and decking.
TWP Wood Sealer is Resistant to Mold and Mildew – Special mildewcides inhibit the growth of mold and mildew preventing premature discoloration.
TWP 100, TWP 1500 series are EPA registered wood preservatives and rated #1 in leading consumer magazines.
- Excellent longevity on both vertical and horizontal surfaces.
- Will not peel. TWP is a penetrating stain, not a film former.
- The professional choice for all exterior wood surfaces.
- Semi-transparent stain preserves natural wood color.
- Repels water.
- Aids in color retention.
Coverage:
TWP Wood Deck Stain applies at about 150-300 feet per gallon. Actual coverage varies depending on wood porosity.
Two coats “wet on wet” are recommended for maximum protection. TWP Wood Deck Stain must penetrate into the wood for optimal results.
Please Note:
Due to these specific states, VOC regulations TWP 100 series cannot be shipped to them: California, Connecticut, Colorado, Rhode Island, Maine, Massachusetts, New Hampshire, Vermont, Delaware, District of Columbia, Maryland, New Jersey, New York, Northern VA, Pennsylvania, Ohio, Illinois, Indiana
TWP 1500 series can be shipped to all 50 states.
TWP is a registered trademark of AMTECO, Inc.
Not sure if you saw last question concerning applying twp100 over the Armstrong-Clark product?
Sorry, did not see it. You will have to strip and brighten if switching stain brands. Use this kit: https://www.opwdecks.com/restore-a-deck-stripper-brightener-kit.htm
What is the difference between 100 and 1500 series?
VOC compliance for certain states of the USA. The 100 cannot be used in all states while the 1500 can.
I ordered Amstrong 2 years, my order says the color is #1, what is the color on the chart?
The 1 on the order has nothing to do with the stain color. You bought Semi-Trans Rustic Brown.
Yes it can be sprayed.
Hello. Can TWP 100 be applied using a paint sprayer such as Wagner? I have a lot of railing and pickets to stain and this would save a tremendous amount of time and effort. Thanks!
NC allows both. More pigment in the 1500 can give better UV protection. 100 Series penetrates deeper which mean it has less chance of wearing. Most use the 100 Series for decks in NC.
For use in Asheville NC, what would be the deciding factor(s) between the TWP 101 and the TWP 1501. What difference do the amount of solids have on the stain? Thank you.
No shine. You cannot have a shiny finish on a deck. It will peel.
Is the finish flat or a simi gloss. Most of the products I see have a flat finish
Yes we ship both of those to Canada.
Hi,
Do you ship Armstrong or Defy Deck Stain to Ontario Canada?
TWP 100 and 1500 are not legal to be shipped to Canada.
Do you ship this product(TWP 100) to Quebec / Canada ?
You need to apply wet on wet. 10 gallons will be enough for one coat but probably not enough for two coats. You would need another 5 gallon most likely.
Normally 9 hours would be okay but it does depend on the wood.
I am goining to be appling two coates of twp 101 ceder tone stain to 1500 sqft of ceder siding. Is it nessarry to apply second coat while it’s
still wet or is it ok if there is two or three days between coates.
I bought 10 gal from you, do you think that will be enough?
looks like rain early tomorrow morning, wondering if i should paint now. it will have about 9 hours drying time. how long do i need?
thanks.
No need to strip unless it has failed unevenly. Please read this for help:
Deck Stain Help ([url]http://www.opwdecks.com/deck-staining-help.htm[/url])
Question. I applied TWP last year and I need to re-apply this year. Do I need to remove last year’s stain before re-coating?
how to strip 100 and 500 series when restoring the deck after 2-3 years?
TWP stains can be sprayed with a pump or airless sprayer.