I would like to review the application instructions, but I cannot find them. Are they available?
-
We will reply to your comment shortlyPREPARATION
Clean dirt, wax, grease, oil, and other contaminants from the surface. Be sure to remove any foreign coating unless the previous coating is the same or similar solvent-based sealer. Make sure the surface is clean, dry, and sound. Clean oily concrete with CLEANER DEGREASER NEUTRALIZER. Use a bristle brush for heavily oiled spots. If the surface is slick, etch with ETCH & CLEAN and follow with CLEANER DEGREASER NEUTRALIZER. Rinse well with a pressure washer. Allow 24 hours to
dry. Apply only when surface and air temperatures are above 50° F and below 90° F. Do not apply to excessively hot surfaces as rapid drying may cause bubbles to form. For pavers, sweep away any loose sand.
APPLICATION
When applying to fresh concrete, wait until all bleed water has evaporated. For best results apply SUPER SEAL-25 with a roller. A brush may be used where the roller won’t reach. Do not pour directly from the can to the concrete. Apply evenly from a can or other metal container with an appropriate roller. Use a long nap roller for exposed aggregate, a medium nap roller for textured surfaces, and a short nap roller for smooth surfaces. Keep roller soaked by dipping on every stroke. Every few feet turn perpendicular to the first coat and cross roll without re-dipping. Wait until the surface is tack-free if applying a second coat. The continual dipping with the first coat gives a heavy application and the cross-rolling allows for an even application. SUPER SEAL-25 may be sprayed using a solvent resistant sprayer. Clean up immediately with aromatic solvent such as A-1 Solvent or Xylene. Do not thin product.